![]() [ Once everything was wired up I plugged the USB into the Uno and applied power to the Uno (the GEN6 will get it's power from the Uno). ![]() Once uploaded I powered both the GEN6 and the UNO off and wired the Uno to the GEN6's ISP pins as shown in the link below. ![]() On line 81 I uncommented #define USE_OLD_STYLE_WIRING and uploaded the sketch to my Uno. You need to connect the Uno to the PC and open the example sketch ArduinoISP (it is number 11). Since I do not have an ISP programmer I used an Arduino Uno R3 as an ISP. Once added you are ready to burn the bootloader from the Arduino IDE via the ISP method. [ Now the Arduino IDE 1.8.5 does not have native support for the Sanguino based boards, so you need to download the files for that board and put in the. I downloaded Arduino IDE 1.8.5 and installed it from: Marlin 1.1.8 needs to be compiled in something newer than Arduino IDE 1.6.8. So as I am sure you have found out the GEN6 board has an older bootloader which is most likely from Arduino legacy days (00XX). Ok so I got over my fear of bricking the only controller for this printer and was finally able to get Marlin 1.1.8 on my GEN6 board.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |